BL120 • BL121 • BL122 • BL123 Swimming Pool Controllers for measurement, and control of pH, and Chlorine The Hanna Instruments® BL12x swimming pool controllers are automatic systems, specially designed to measure and control pH and free-chlorine levels. The chlorine level is measured based on the ORP or REDOX principle. An increase in the ORP value correlates with an increase in the freechlorine level. pH and ORP testing are done together for e³cient disinfection and control. The e³cacy of sanitizers, such as chlorine, depends on a controlled pH value. The ORP value is the most consistent indicator of the sanitizing e¨ectiveness of the pool or spa. Typically, 650-750 mV at 7.2 pH indicates proper water treatment. The BL122 & BL123 o¨er the added benet of allowing remote access and visualizing of measured data via Cloud connectivity. All measurements and main events are sent to Hanna Cloud through the Ethernet connection. For BL121 & BL123 three analog outputs are available that allow connection to an external chart recorder or datalogger to monitor any of the three measured parameters. The outputs are scalable, o¨ering increased ºexibility and better resolution as needed. Any of the controllers can be paired with the HI1036-18XX digital probe. The probe incorporates pH, ORP and temperature sensors along with a matching pin. It was specially designed to detect a broken electrode based on a shifted zero potential value, around 4 pH. The HI1036-18XX uses an Ag/AgCl reference with 3.5 M KCl. The ORP values are referenced to it. Measurement data stored on the probe is transferred to the controller via a digital connection; thus eliminating noise and static due to high impedance signals carried by the cable. Multiple Congurations BL12x swimming pool controllers are available in two congurations: · in-line, for direct probe installation and chemical injection fittings into existing piping · flow cell, for calibration and probe maintenance without having to shut down the recirculation pump For compliance monitoring, each of the BL12x family has a built-in datalogger. Congurable logging intervals can be set at 30 seconds; 1 minute; 2 minutes; 5 minutes; 10 minutes; 15 minutes; 30 minutes; 60 minutes, with a new log starting new each day, when the instrument is calibrated or settings have changed. Logged data include pH, ORP, and temperature values, last calibration data, setup conguration, and any event data. For review and storage, the users can transfer data to a PC using a ºash drive and the USB port. The meter can store 100 logs. The BL12x swimming pool controller is an automatic system, but it is advisable that users check the controller and verify pH and free-chlorine levels (in mg/L or ppm) in the pool using a portable colorimeter and pH meter. Main Features • Two built-in peristaltic dosing pumps with Proportional control • Manual control for pump priming • Overfeed protection using overtime safety timer • Resumes dosing on restart in case of power failure • Level input to stop control without reagents • Interlocked pH-ORP control (i.e. ORP control only runs when the pH set point has been reached) • Multicolored LED indicators for dosing, meter status and service • Real-time graph display • Programmable alarms • Password protection Main Benets • All-in-one solution for automatic control of pH and chlorine levels • ORP (chlorine) dosing consent ensures pH value is correct before dosing BL12x Swimming Pool Controllers Comparison Table pH measurement ORP measurement Acid dosing pump Chlorine dosing pump Analog outputs Hanna Cloud connectivity BL120 • • • • BL121 • • • • • BL122 • • • • • BL123 • • • • • • 15 Process Instrumentation 15.22 | www.hannainst.com controllers
RkJQdWJsaXNoZXIy MTI3NTM=